Nextwindow 2700 OverlayTouch 82" Instrukcja Obsługi

16 Installing the Serial Communications Software For the serial option, you need to install software on the computer to provide communications to th

17 Serial Calibration With a clear desktop on the computer, 1. Click the serial icon on the taskbar , then select Serial Config. 2. Click the [

18 Calibration notes When moving your finger to the next calibration point, lift it straight off the screen, making sure you don’t drag it across th

19 Operating the Touch Screen Mouse actions NextWindow's 2700 Touch Overlay provides full mouse functionality—click, drag, double-click and r

20 Operating with an Apple Mac Computer To operate with an Apple Mac computer, the 2700 Touch Overlay must be in Apple Mac mode. This is achieved by

21 Calibrationbutton  The mouse pointer automatically moves to a position at the top left of the screen.  Touch and hold your fing

22 Cleaning the Touch Screen To clean the touch screen, use a lint-free, soft cloth dampened with standard, household glass cleaning solution as fol

23 Troubleshooting This section provides some solutions to possible problems that might occur with the touch screen. If the problem persists, cont

24 “USB not recognized” message appears on screen To remedy, unplug the USB cable, then plug in the USB cable again. If this does not fix the proble

25 3. On the Properties screen, verify that the location refers to the touch screen. 4. Close the Properties screen. 5. With USB Composite Dev

26 Regulatory Compliance Information Federal Communication Commission (FCC) Statement (For the United States of America.) This equipment has been te

27 Damaged Goods In the event of damage to this Product or packaging you should immediately advise the shipper and the reseller who sold you the p

28 Disclaimers and Other Provisions: EXCEPT AS SPECIFICALLY STATED IN THIS LIMITED WARRANTY (A) SUPPLIER PROVIDES THE PRODUCT WITH ALL FAULTS, (B) T

11 USB Installation USB installations require no special software; the touch overlay communicates directly with the computer’s operating system vi

15 Connecting the Serial Cable Connect the 4-pole jack plug into the touch overlay. Connect the DB9 serial connector at the other end of